Which key element would the flow entry contain?

A network administrator is planning a flow table entry that provides fast failover for the traffic flow in case a link fails. Which key element would the flow entry contain?A . a group identifier that specifies at least two output portsB . a backup set action that modifies the packet...

August 30, 2019 No Comments READ MORE +

How can the administrator fix the configuration?

Refer to the exhibit. A network administrator sends the cURL command shown in the exhibit to an HP VAN SDN Controller team in order to add a region to that team. The addresses are as follows: -The team IP address is 192.168.56.10. -The team members IP addresses are 192.168.56.14, 192.168.56.15,...

August 29, 2019 No Comments READ MORE +

How should the administrator change these entries to resolve the error?

Refer to the exhibit. The exhibit shows the four OpenFlow table entries for an HP ProVision switch that is controlled by an HP VAN SDN Controller. The switch uses active mode for the OpenFlow instance. The network administrator wants the switch to have this behavior: The current entries have an...

August 27, 2019 No Comments READ MORE +

How should the network administrator further configure the HP switches to work with this application?

A company is deploying the HP Network Visualizer SDN Application. The HP switches already have the correct OpenFlow settings for the HP VAN SDN Controller to control them. How should the network administrator further configure the HP switches to work with this application?A . Configure the OpenFlow VLANs as remote...

August 26, 2019 No Comments READ MORE +

How should administrators fix the problem on each switch?

A company is using MCE to create a multi-tenant data center solution. Network administrators want to isolate all management functions in a VPN instance “Management”. Each switch has an IP address in 10.0.2.0/24 on its Management Ethernet port, and HP IMC manages the switches on these IP addresses. Administrators assign...

August 26, 2019 No Comments READ MORE +

What should be configured on the Ten-GigabitEthernet1/0/1 interface of Switch1?

Refer to the exhibit. The switches shown in the exhibit are HP Comware switches that support FCoE. The servers access the storage using FCoE. What should be configured on the Ten-GigabitEthernet1/0/1 interface of Switch1?A . a QoS policy for Enhanced Transmission Selection (ETS)B . the LLDP TLVs for data center...

August 26, 2019 No Comments READ MORE +

How should you configure the query filter?

HOTSPOT Your network contains an Active Directory domain named contoso.com. You are deploying Microsoft Advanced Threat Analytics (ATA) to the domain. You install the ATA Gateway on a server named Server1. To assist in detecting Pass-the-Hash attacks, you plan to configure ATA Gateway to collect events. You need to configure...

August 25, 2019 No Comments READ MORE +

How should the administrator begin to set up the instance?

An HP ProVision switch supports VLANs 1, 10, 20, and 30. A network administrator wants to create an OpenFlow instance on the switch. This instance should only apply to VLAN 10. The switch reaches the HP VAN SDN Controller in VLAN 20. How should the administrator begin to set up...

August 23, 2019 No Comments READ MORE +

Which design in the exhibit shows valid choices for HP switches?

Refer to the exhibit. Which design in the exhibit shows valid choices for HP switches?A . AB . BC . CD . DView AnswerAnswer: B Explanation: References: http://h10032.www1.hp.com/ctg/Manual/c04214037

August 22, 2019 No Comments READ MORE +