HP HPE2-T37 Using HPE OneView Online Training
HP HPE2-T37 Online Training
The questions for HPE2-T37 were last updated at Jan 19,2025.
- Exam Code: HPE2-T37
- Exam Name: Using HPE OneView
- Certification Provider: HP
- Latest update: Jan 19,2025
What step must be taken to add an HPE SuperDome Flex to an existing OneView environment
- A . A Rack Management Controller must be added to HPE OneView.
- B . HPE Superdome Flex can be added to HPE OneView after at least one nPAR is created.
- C . Each HPE Superdome Flex chassis must be added Individually using BMC IP.
- D . HPE Superdome Flex complex can be added by adding base chassis of this complex.
How will setting the Purpose field within the network definition of a server profile impact the network traffic?
- A . network purpose can give higher priority for a specific type of traffic
- B . network purpose will impact the traffic only if Virtual Connect modules are used
- C . network purpose will define QoS within Logical Interconnect
- D . network purpose does not affect the behavior of the network
HOTSPOT
Click the option that will allow you to disable virtual MAC addresses or generate a new pool of virtual Worldwide Names.
Which statement about an HPE OneView server profile is true?
- A . A server profile can be created only for HPE BladeSystem, HPE Synergy, and HPE Superdome Flex servers.
- B . A server profile created for a specific server hardware type cannot be moved to a server with a different server hardware type.
- C . A server profile can be used to configure a local storage controller, but cannot be used to configure SAN-based storage.
- D . A server profile can be used to update firmware and drivers when the operating system on the server is up and running.
You originally configured boot mode for HPE ProLiant Gen10 server to ‘Legacy BIOS’ in an HPE OneView server profile and deployed an operating system. A few weeks later, you change the boot mode to the ‘UEFI optimized’ to leverage some features provided by this mode.
What must you do next?
- A . reset an il_0 management processor to activate the new boot mode for the server
- B . reinstall an operating system, as UEFI is using different drive format than Legacy BIOS
- C . reset BIOS settings to the defaults so UEFI settings can be applied
- D . reset BIOS settings to the defaults through the server profile after changing the boot mode
HOTSPOT
Click the option that will allow you to update the firmware of master and satellite modules.
Which action is allowed on storage pools managed by HPE OneView?
- A . Volume provisioning
- B . Setting storage pool replication
- C . Changing storage pool RAID level
- D . Changing storage pool capacity
HOTSPOT
As a part of troubleshooting, you have to reinstall the same version of the firmware on an HPE Synergy Compute Module. Click the area within the Firmware section of the server profile that will allow you to install the same firmware version.
You want to update the firmware for only two HPE Synergy Virtual Connect SE 32Gb FC Modules of a large environment.
From which level must this procedure be initiated?
- A . Logical Enclosure
- B . Logical Interconnect Group
- C . Logical Interconnect
- D . Server Profile
You are creating a Logical Interconnect Group for a three-frame HPE Synergy solution with HPE Virtual Connect SE100Gb F32 Modules for Synergy.
In which scenario should you set redundancy for master modules to be highly available?
- A . When storm control or loop protection will be enabled for Virtual Connect modules
- B . When each of the frames has two Virtual Connect modules installed
- C . When each Virtual Connect module is installed in different frame
- D . When each Virtual Connect module is installed in different fabric
Latest HPE2-T37 Dumps Valid Version with 40 Q&As
Latest And Valid Q&A | Instant Download | Once Fail, Full Refund
