GB0-191-ENU

 There is a default route in the router's routing table, the destination network segment and mask are 0.0.0.0 , and the next hop is the router's S0 / 0 interface, then the following description of this route is correct ______ . (Multiple choices)A .  When the router receives a packet destined to the destination address 120.1.1.1 , if there is no...

 An empty configuration MSR router RTA is connected to two routers RTB and RTC running in OSPF Area 0 through GE0 / 0 and GE1 / 0 respectively . RTA interface GE0 / 0 and GE1 / 0 of the IP addresses are 192.168.3.2/24 and 192.168.4.2/24 . Add the following configuration on RTA : [MSR-ospf-1] area 0.0.0.0 [MSR-ospf-1-area-0.0.0.0]network 192.168.0 0.0.3.255 [MSR-GigabitEthernet0/0]ospf cost 2 [MSR-GigabitEthernet1/0]ospf dr-priority 0 Then the correct description about the above configuration is _____ . (Multiple choices)A .  This configuration MSR router the GE0 / 0 , GE1...

 The device that realizes network interconnection on the network layer is ______ .A .  RouterB .  SwitchC .  HubD .  RepeaterView AnswerAnswer:   A Explanation: Routers and Layer 3 switches

The two empty MSR routers are connected by the way shown in the figure. By configuring the IP address, the GE0 / 0 interfaces of the two routers can communicate with each other. Now the following configurations are added to the two routers: RTA: [RTA]ospf [RTA-ospf-1]area 0 [RTA-ospf-1-area-0.0.0.0]network 192.168.1.1 0.0.0.3 [RTA-GigabitEthernet0/0]ospf dr-priority 2 DAF: [RTB]ospf [RTB-ospf-1]area 0 [RTB-ospf-1-area-0.0.0.0]network 192.168.1.1...