Given the information in the graphic and assuming that the router and switch2 are configured properly, which of the following commands should be issued on switch 1 to correct this problem?

The network administrator cannot to switch 1 over a telnet session, although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.

Given the information in the graphic and assuming that the router and switch2 are configured properly, which of the following commands should be issued on switch 1 to correct this problem?
A . Switch1(config)# i nterface fa0 /1
Switch1(config-if)# ip address 192.168.24.3.255.255.255.0
B . Switch1 (config)# interface fa0/1
Switch1 (config-if)# switchport mode trunk
C . Switch 1 (config)# i nterface fa0 /1
Switch1 (config-if)# duplex full
Switch1 (config-if)# speed 100
D . Switch1 (config-if)# default-gateway 192.168.24.1
E . Switch1 (config)# line con 0
Switch1(config-line)# password cisco
Switch1 (config-line)#login

View Answer

Answer: D