- All Exams Instant Download
Based on the exhibit, which change in the measured latency will make T_MPLS_0 the new preferred member?
Refer to the exhibit. The exhibit shows the SD-WAN rule status and configuration. Based on the exhibit, which change in the measured latency will make T_MPLS_0 the new preferred member?A . When T_INET_0_0 and T_MPLS_0 have the same latency.B . When T_MPLS_0 has a latency of 100 ms.C . When...
Which configuration change is required if the responder FortiGate uses a dynamic routing protocol to exchange routes over IPsec?
Refer to the exhibit. Which configuration change is required if the responder FortiGate uses a dynamic routing protocol to exchange routes over IPsec?A . type must be set to static.B . mode-cfg must be enabled.C . exchange-interface-ip must be enabled.D . add-route must be disabled.View AnswerAnswer: D Explanation: for using...
Which are two benefits of using CLI templates in FortiManager? (Choose two.)
Which are two benefits of using CLI templates in FortiManager? (Choose two.)A . You can reference meta fields.B . You can configure interfaces as SD-WAN members without having to remove references first.C . You can configure FortiManager to sync local configuration changes made on the managed device, to the CLI...
Based on the FortiGate configuration shown in the exhibits, what issue might you encounter when creating an SD-WAN zone for port1 and port2?
Refer to the exhibits. Exhibit B Exhibit A shows the system interface with the static routes and exhibit B shows the firewall policies on the managed FortiGate. Based on the FortiGate configuration shown in the exhibits, what issue might you encounter when creating an SD-WAN zone for port1 and port2?A...
What is the route-tag setting in an SD-WAN rule used for?
What is the route-tag setting in an SD-WAN rule used for?A . To indicate the routes for health check probes.B . To indicate the destination of a rule based on learned BGP prefixes.C . To indicate the routes that can be used for routing SD-WAN traffic.D . To indicate the...
What must you configure on the IPsec phase 1 configuration for ADVPN to work with SD-WAN?
Refer to the exhibit, which shows the IPsec phase 1 configuration of a spoke. What must you configure on the IPsec phase 1 configuration for ADVPN to work with SD-WAN?A . You must set ike-version to 1.B . You must enable net-device.C . You must enable auto-discovery-sender.D . You must...
Based on the policies shown in the exhibits, what configuration change must be made so FortiGate performs traffic shaping on YouTube traffic?
Refer to the exhibits. Exhibit A - Exhibit B - Exhibit A shows the traffic shaping policy and exhibit B shows the firewall policy. The administrator wants FortiGate to limit the bandwidth used by YouTube. When testing, the administrator determines that FortiGate does not apply traffic shaping on YouTube traffic....
Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?
Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?A . diagnose sys sdwan intf-sla-logB . diagnose sys sdwan health-checkC . diagnose sys sdwan logD . diagnose sys sdwan sla-logView AnswerAnswer: D Explanation: SD-WAN 7.2 Study Guide page 321...
Which two settings can you configure to speed up routing convergence in BGP? (Choose two.)
Which two settings can you configure to speed up routing convergence in BGP? (Choose two.)A . update-sourceB . set-route-tagC . holdtime-timerD . link-down-failoverView AnswerAnswer: C, D
Which two performance SLA protocols enable you to verify that the server response contains a specific value? (Choose two.)
Which two performance SLA protocols enable you to verify that the server response contains a specific value? (Choose two.)A . httpB . icmpC . twampD . dnsView AnswerAnswer: A, D Explanation: Pages 85,86 in Study guide 7.0 Pages 100,101 in Study guide 7
