Which three parameters are available to configure SD-WAN rules? (Choose three.)
Which three parameters are available to configure SD-WAN rules? (Choose three.)A . Application signatures B. Type of physical link connection C. URL categories D. Source and destination IP address E. Internet service database (ISDB) address objectView AnswerAnswer: A,D,E Explanation: SD-WAN 6.4.5 Guide Page 76. https://docs.fortinet.com/document/fortigate/7.2.1/administration-guide/22371/sd-wan-rules-best-quality
If port2 is detected dead by FortiGate, which expected behavior is correct?
Refer to the exhibits. Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SD-WAN member and the static routes configuration. If port2 is detected dead by FortiGate, which expected behavior is correct?A . Port2 becomes alive after one successful probe is detected. B. The SD-WAN interface becomes...
Which feature enables SD-WAN to combine IPsec VPN dynamic shortcut tunnels between spokes and a static tunnel to the hub?
Which feature enables SD-WAN to combine IPsec VPN dynamic shortcut tunnels between spokes and a static tunnel to the hub?A . ADVPN B. GRE C. SSLVPN D. OCVPNView AnswerAnswer: A
Which statement about the command route-tag in the SD-WAN rule is true?
Refer to the exhibit. Which statement about the command route-tag in the SD-WAN rule is true?A . It enables the SD-WAN rule to load balance and assign traffic with a route tag B. It tags each route and references the tag in the routing table. C. It uses route tags...
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule?
Refer to the exhibit. Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)A . Set priority 10. B. Set cost 15. C. Set load-balance-mode source-ip-ip-based. D. Set source 100.64.1.1.View...
Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true?
Refer to exhibits. Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate. Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two.)A . All the existing sessions that do not use SNAT will...
Based on the exhibits, which statement is correct?
Refer to exhibits. Exhibit A. Exhibit B. Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members. Based on the exhibits, which statement is correct? A. The dead member interface stays unavailable until an administrator manually brings the interface back. B....
Based on the exhibits, which statement is correct?
Refer to exhibits. Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output. Based on the exhibits, which statement is correct?A . Both SD-WAN member interfaces have used separate SLA targets. B. The SLA state of port1 is dead after five unanswered requests by the SLA servers....
Which two statements about the status of the VPN tunnel are true?
Refer to the exhibit. Which two statements about the status of the VPN tunnel are true? (Choose two)A . There are separate virtual interfaces for each dial-up client. B. VPN static routes are prevented from populating the FortiGate routing table. C. FortiGate created a single IPsec virtual interface that is...
Which diagnostic command can you use to show interface-specific SLA logs for the last 10 minutes?
Which diagnostic command can you use to show interface-specific SLA logs for the last 10 minutes?A . diagnose sys sdwan log B. diagnose sys sdwan health-check C. diagnose sys sdwan intf-sla-log D. diagnose sys sdwan sla-logView AnswerAnswer: D Explanation: diagnose sys sdwan intf-sla-log -> shows only bandwidth utilization diagnose sys...