What is the diagnose test application ipsmonitor 5 command used for?
What is the diagnose test application ipsmonitor 5 command used for?A . To disable the IPS engineB . To provide information regarding IPS sessionsC . To restart all IPS engines and monitorsD . To enable IPS bypass modeView AnswerAnswer: C Explanation: The command diagnose test application ipsmonitor 5 is used...
Which changes must the administrator perform to ensure the server at 10.4.0.1/24 receives the echo reply from the laptop at 10.1.0.1/24?
Refer to the exhibit. FortiGate has already been configured with a firewall policy that allows all ICMP traffic to flow from port1 to port3. Which changes must the administrator perform to ensure the server at 10.4.0.1/24 receives the echo reply from the laptop at 10.1.0.1/24?A . Enable asymmetric routing under...
Which statement is false?
Refer to the exhibit, which shows the omitted output of a real-time OSPF debug Which statement is false?A . A password has been configured on the local OSPF router but is not shown in the outputB . The Hello packet is being sent from an OSPF router with ID 0.0.0.112.C...
Based on the output, which two statements are correct?
Refer to the exhibit, which contains the partial output of a diagnose command. Based on the output, which two statements are correct? (Choose two.)A . The remote gateway IP is 10.200.5.1.B . The remote gateway has quick more selectors containing a destination subnet of 10.1.2.0/24.C . DPD is disabled.D ....
Which of the following regarding protocol states is true?
Which of the following regarding protocol states is true?A . proto_state=00 indicates that UDP traffic flows in both directions.B . proto_state-01 indicates an established TCP session.C . proto_state=10 indicates an established TCP session.D . proto state=01 indicates one-way ICMP traffic.View AnswerAnswer: C Explanation: Understanding protocol states: proto_state=00: Indicates no traffic...
Which two statements are true?
Refer to the exhibit, which shows a truncated output of a real-time RADIUS debug. Which two statements are true? (Choose two.)A . The RADIUS server queried for authentication is located at IP address 172.25.188.164.B . Authentication was unsuccessful.C . The authentication scheme used was pop3.D . Authentication was successfulE ....
Which three conditions are required for two FortiGate devices to form an OSPF adjacency? (Choose three.)
Which three conditions are required for two FortiGate devices to form an OSPF adjacency? (Choose three.)A . OSPF link costs match.B . OSPF interface priority settings are uniqueC . OSPF interface network types matchD . Authentication settings match.E . OSPF router IDs are unique.View AnswerAnswer: CDE Explanation: OSPF Interface Network...
Which statement is correct regarding LDAP authentication using the regular bind type?
Which statement is correct regarding LDAP authentication using the regular bind type?A . The regular bind type goes through four steps to successfully authenticate a user.B . The regular bind type cannot be used if users are authenticated using sAMAccountName.C . The regular bind type is the easiest bind type...
Which two conditions would prevent a static route from being added to the routing table? (Choose two.)
Which two conditions would prevent a static route from being added to the routing table? (Choose two.)A . The next-hop IP address is unreachable.B . The interface specified in the route configuration is downC . The route has a lower priority value than another route to the same destination.D ....
Which statement about FortiGate behavior relating to this session is true?
Refer to the exhibit, which shows a session table entry. Which statement about FortiGate behavior relating to this session is true?A . FortiGate forwarded this session without any inspection.B . FortiGate is performing a security profile inspection using the CPU.C . FortiGate redirected the client to the captive portal to...