- All Exams Instant Download
What can be concluded about the debug output in this scenario?
Refer to the exhibit, which shows the output of a diagnose command. What can be concluded about the debug output in this scenario?A . Servers with a negative TZ value are less preferred for rating requests. B. There is a natural correlation between the value in the Packets field and...
What should the administrator check?
Examine the output from the 'diagnose debug authd fsso list' command; then answer the question below. # diagnose debug authd fsso list ―FSSO logons-IP: 192.168.3.1 User: STUDENT Groups: TRAININGAD/USERS Workstation: INTERNAL2. TRAINING. LAB The IP address 192.168.3.1 is NOT the one used by the workstation INTERNAL2. TRAINING. LAB. What should...
If the HA ID for the primary unit is zero (0), which statement about the output is true?
Refer to the exhibit, which contains the output of diagnose sys session list. If the HA ID for the primary unit is zero (0), which statement about the output is true?A . This session cannot be synced with the slave unit. B. The inspection of this session has been offloaded...
Which statement about the exhibit is true?
Refer to the exhibit, which contains the output of a BGP debug command. Which statement about the exhibit is true?A . The local router has received a total of three BGP prefixes from all peers. B. The local router has not established a TCP session with 100.64.3.1. C. Since the...
Which two statements about this debug output are correct?
Refer to the exhibit, which contains partial output from an IKE real-time debug. Which two statements about this debug output are correct? (Choose two.)A . The remote gateway IP address is 10.0.0.1. B. The initiator provided remote as its IPsec peer ID. C. It shows a phase 1 negotiation. D....
Which statements are correct regarding the output?
View the exhibit, which contains the output of get sys ha status, and then answer the question below. Which statements are correct regarding the output? (Choose two.)A . The slave configuration is not synchronized with the master. B. The HA management IP is 169.254.0.2. C. Master is selected because it...
What is the diagnose test application ipsmenitor 5 command used for?
What is the diagnose test application ipsmenitor 5 command used for?A . To enable IPS bypass mode B. To disable the IPS engine C. To restart all IPS engines and monitors D. To provide information regarding IPS sessionsView AnswerAnswer: A Explanation: # diagnose test application ipsmonitor 5: Toggle bypass status...
Which statement is correct regarding this command?
An administrator has configured two FortiGate devices for an HA cluster. While testing the HA failover, the administrator noticed that some of the switches in the network continue to send traffic to the former primary unit. The administrator decides to enable the setting link-failed-signal to fix the problem. Which statement...
Which statements are true regarding the above output?
Examine the output of the ‘get router info ospf interface’ command shown in the exhibit; then answer the question below. Which statements are true regarding the above output? (Choose two.)A . The port4 interface is connected to the OSPF backbone area. B. The local FortiGate has been elected as the...
Which two statements about this debug output are correct?
Refer to the exhibit, which contains partial output from an IKE real-time debug. Which two statements about this debug output are correct? (Choose two.)A . The initiator provided remote as its IPsec peer ID. B. It shows a phase 2 negotiation. C. Perfect Forward Secrecy (PFS) is enabled in the...
