Which statements are true regarding the above output?

Examine the output of the ‘get router info ospf interface’ command shown in the exhibit; then answer the question below. Which statements are true regarding the above output? (Choose two.)A . The port4 interface is connected to the OSPF backbone area.B . The local FortiGate has been elected as the...

March 3, 2025 No Comments READ MORE +

Which two statements about an auxiliary session are true? (Choose two.)

Which two statements about an auxiliary session are true? (Choose two.)A . With the auxiliary session setting enabled, ECMP traffic is accelerated to the NP6 processor.B . With the auxiliary session setting disabled, for each traffic path, FortiGate will use the same auxiliary session.C . With the auxiliary session disabled,...

March 3, 2025 No Comments READ MORE +

Which option and value pair will allow more specific detection?

View the following exhibit, which contains the sniffer output for a passive mode FTP request. An administrator has created the following custom IPS signature to block all FTP requests for passive mode: F-SBID (--attack_id 1002; --name "Block.FTP "; --protocol tcp; --flow from_client; --pattern "PASV"; --no_case;) Soon after the signature is...

March 1, 2025 No Comments READ MORE +

Based on the debug output, what configuration changes can the administrator make to the local gateway to resolve the phase 1 negotiation error?

View the exhibit, which contains the partial output of an IKE real time debug, and then answer the question below. The administrator does not have access to the remote gateway. Based on the debug output, what configuration changes can the administrator make to the local gateway to resolve the phase...

February 25, 2025 No Comments READ MORE +

Which two statements about the output are true?

Refer to the exhibit, which contains the output of a diagnose command. Which two statements about the output are true? (Choose two.)A . This is an expected session created by a session helperB . This is an expected session created by an application control profile.C . Traffic in the original...

February 24, 2025 No Comments READ MORE +

What should the administrator check?

A corporate network allows internet Access to FSSO users only. The FSSO user student does not have internet access after successfully logged into the Windows AD network. The output of the ‘diagnose debug authd fsso list’ command does not show student as an active FSSO user. Other FSSO users can...

February 23, 2025 No Comments READ MORE +

Why is the default route that uses port2 not in the output of the second command?

Examine these partial outputs from two routing debug commands: # get router info routing-table database S       0.0.0.0/0 [20/0] via 100.64.2.254, port2, [10/0] S    *> 0.0.0.0/0 [10/0] via 100.64.1.254, port1 # get router info routing-table all S*      0.0.0.0/0 [10/0] via 100.64.1.254, port1 Why is the default route that uses port2 not...

February 22, 2025 No Comments READ MORE +

Which configuration change will make the local peer advertise this prefix?

Examine the following routing table and BGP configuration; then answer the question below. The BGP connection is up, but the local peer is NOT advertising the prefix 192.168.1.0/24. Which configuration change will make the local peer advertise this prefix?A . Enable the redistribution of connected routers into BGP.B . Enable...

February 17, 2025 No Comments READ MORE +

What does the log mean?

Examine the following traffic log; then answer the question below. date-20xx-02-01 time=19:52:01 devname=masterdevice_id="xxxxxxx" log_id=0100020007 type=event subtype=system pri critical vd=root service=kemel status=failure msg="NAT port is exhausted." What does the log mean?A . There is not enough available memory in the system to create a new entry in the NAT port table.B...

February 14, 2025 No Comments READ MORE +

Assuming all the appropriate firewall policies are configured, which two pings will FortiGate route?

Refer to the exhibit, which contains a partial routing table. Assuming all the appropriate firewall policies are configured, which two pings will FortiGate route? (Choose two.)A . Source IP address 10.1.0.24, Destination IP address 10.72.3.20.B . Source IP address 10.72.3.52, Destination IP address 10.1.0.254.C . Source IP address 10.72.3.27, Destination...

February 8, 2025 No Comments READ MORE +