Fortinet NSE7_SDW-6.4 Fortinet NSE 7 – SD-WAN 6.4 Online Training
Fortinet NSE7_SDW-6.4 Online Training
The questions for NSE7_SDW-6.4 were last updated at Jan 05,2025.
- Exam Code: NSE7_SDW-6.4
- Exam Name: Fortinet NSE 7 - SD-WAN 6.4
- Certification Provider: Fortinet
- Latest update: Jan 05,2025
Question #21
Refer to Exhibit:
Based on the exhibit, which algorithm does SD-WAN use to distribute traffic that does not match any of the SD-WAN rules, among the member interfaces?
- A . All traffic from a source IP to a destination IP Is sent to the same interface.
- B . All traffic from a source IP Is sent to the most used Interface.
- C . All traffic from a source IP to a destination IP is sent to the least used interface.
- D . All traffic from a source IP is sent to the same interfaces.
Correct Answer: A
Question #22
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A . Set priority 10.
- B . Set cost 15.
- C . Set load-balance-mode source-ip-ip-based.
- D . Set source 100.64.1.1.
Correct Answer: A,B
Question #23
Refer to the exhibit.
Which two statements about the debug output are true? (Choose two)
- A . The debug output shows per-IP shaper values and real-time readings.
- B . FortiGate provides statistics and reading based on historical traffic logs.
- C . Traffic being controlled by the traffic shaper is under 100 KB/s.
- D . This traffic shaper drops traffic that exceeds the set limits.
Correct Answer: C,D
Question #24
Refer to the exhibit.
Which conclusion about the packet debug flow output is correct?
- A . The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.
- B . The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the firewall policy, and the packet was dropped.
- C . The packet size exceeded the outgoing interface MTU.
- D . The total number of daily sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.
Correct Answer: A
Question #25
Which diagnostic command can you use to show the SD-WAN rules interface information and state?
- A . diagnose sys sdwan route-tag-list.
- B . diagnose sys sdwan service.
- C . diagnose sys sdwan member.
- D . diagnose sys sdwan neighbor.
Correct Answer: B
B
Explanation:
https://community.fortinet.com/t5/FortiGate/Technical-Tip-Diagnostic-commands-to-check-the-status-of-the-SD/ta-p/194246
B
Explanation:
https://community.fortinet.com/t5/FortiGate/Technical-Tip-Diagnostic-commands-to-check-the-status-of-the-SD/ta-p/194246
Latest NSE7_SDW-6.4 Dumps Valid Version with 35 Q&As
Latest And Valid Q&A | Instant Download | Once Fail, Full Refund
Subscribe
Login
0 Comments
