- All Exams Instant Download
What is causing the ping loss?
Refer to the exhibits. An organization has a network with the following configuration: * 2x C-Series chassis in a VLT * Identical 10Gb line cards in each C-Series chassis * A Hyper-V Server directly connected to Te 0/1 on each C-Series chassis * A VLT Port-Channel connected to a two...
Which phrase correctly describes the current state of spanning-tree on both switches?
The network engineer has two Dell Networking switches: an N-Series and an S-Series. Both switches have the factory default configuration. Which phrase correctly describes the current state of spanning-tree on both switches?A . S-Series Globally Disabled N-Series Globally DisabledB . S-Series Globally Enabled N-Series Globally DisabledC . S-Series Globally Enabled...
Which system behavior is indicated?
The status LED is blinking RED for an N-Series switch. Which system behavior is indicated?A . The switch is booting.B . A noncritical system error has occurred.C . Normal operation is occurring.D . A critical system error has occurred.View AnswerAnswer: B Explanation: References: Dell Networking N-Series N1500, N2000, N3000, and...
Which configuration change should a network engineer apply to resolve this issue?
Refer to the exhibit. A customer has a SAN deployment consisting of a single Dell server and Equallogic storage array on a segregated VLAN communicating over a C9010. The storage arrays are reporting excessive ISCSI retransmits. Which configuration change should a network engineer apply to resolve this issue?A . Flowcontrol...
Which sequence of steps must the engineer complete to remove the vpc peer-link from Port Channel 1?
Refer to the Exhibit. A network engineer receives the output shown when removing MLAG from a pair of N-Series switches. Which sequence of steps must the engineer complete to remove the vpc peer-link from Port Channel 1?A . Shut down the Port Channel interface Issue the no vpc peer-link command...
From the output shown, what are two likely reasons for this result?
A network engineer has configured LACP on two connected S-Series switches. LACP is not formed for port TenGigabitEthernet 0/72. The network engineer has issued “show lacp” to debug the issue. From the output shown, what are two likely reasons for this result? (Choose two.)A . Peer port-channel is configured in...
What are two reasons that the PC is unable to ping other devices?
Refer to the exhibits. A network engineer has worked with PC support to install a new PC. After correctly configuring the PC’s interfaces with valid IP addresses, the PC is not able to ping other devices on the 192.168.13.0/24 network. The output from the PC after executing the command ipconfig...
In an OSPF network, what happens if the OSPF Priority level is set to “0”?
In an OSPF network, what happens if the OSPF Priority level is set to “0”?A . The switch does not become an active BDR or DC . The switch becomes the BDR in the OSPF routing topology.D . The switch becomes the DR in the OSPF routing topology.E . The...
Which two commands should the network engineer use to determine the operation of the LAG?
A network engineer is verifying the configuration of a LAG connection on an S-Series switch. Which two commands should the network engineer use to determine the operation of the LAG? (Choose two.)A . show lacp <interface>B . show interface <port-channel number>C . show port-channel-flow <interface>D . show uplink-state-group <port-channel number>View...
Based on the topology shown, what is the most likely cause of the traffic loss?
Refer to the exhibit. A network engineer is called onsite to troubleshoot replication failure and traffic loss. Whenever replication occurs between SAN A and SAN B, users report traffic loss between sites, and replication ultimately fails due to traffic loss. Based on the topology shown, what is the most likely...
