DES-6321

Which requirement must be met when expanding a VxRail G560F 3 node Cluster with a 4th G Series node in the same chassis?A . Node must be a hybrid nodeB . Node requires only the same processor typeC . Node requires only the same drive configurationD . Node must be...

In a VRail Stretched Cluster deployment. what is the required Round Trip Time (RTT) between sites?A . Primary to Witness site RTT: < 150 ms Secondary to Witness site RTT: < 150 ms Primary to Secondary site RTT: < 10 msB . Primary to Witness site RTT: < 250 ms...

A system administrator wants to pull up the physical view for the VXRail Manager Plug-In to check the status. Where can this be done?A . vSphere Client > VxRail Cluster Monitor > VxRail > AppliancesB . vSphere Client > VxRail Cluster Monitor > vSAN > SupportC . VxRail Manager URL>...

Which log bundles can be included in VxRail automated log collection used for troubleshooting?A . ESXi, Loudmouth, and PTAgentB . Mystic, Loudmouth, and IDRACC . VxRail, Mystic, and vCenterD . VxRail, ESXi, and vCenterView AnswerAnswer: D

By design, which network is required to have IPv6 Multicast enabled in order to set up a VxRail with version 4.7.100?A . Public management networkB . VSAN networkC . vMotion networkD . Private management networkView AnswerAnswer: D

A system administrator wants to check the version of the VxRail Manager Plug-In. Where can this be done?A . vSphere Client > VxRail Cluster > Configure> VxRail SupportB . vSphere Client > Menu Administration > Client Plug-InsC . vSphere Web Client > Menu Administration > Client Plug-InsD . VxRail Manager...

What is the correct sequence of steps used by the VxRail NVT workflow? View AnswerAnswer:

You are in the validation phase of a VxRail deployment with two Dell EMC ToR Switches. Which command should you issue on each of the ToR switches to validate that Link Aggregation has not been configured for VxRail interfaces?A . show port-channel summaryB . show spanning treeC . show vlanD...

You have just upgraded a VxRail Cluster from version 4.5.x to version 4.7.x. You need to ensure that new VxRail 4.7.x nodes will be discovered without having to make any changes to the nodes. What action should you take on the existing configuration?A . In vCenter, set the VLAN ID...

What is a consideration when adding nodes to a VxRail G Series system?A . G560 and G410 nodes are permitted in the same chassisB . All nodes in a G Series chassis must be identicalC . Hybrid and All-Flash nodes are permitted if in different chassisD . Each G Series...