- All Exams Instant Download
How many times must BGP be configured when running symmetric IRB with two VFRs?
How many times must BGP be configured when running symmetric IRB with two VFRs?A . 3B . 5C . 2D . 4View AnswerAnswer: C Explanation: When running symmetric Integrated Routing and Bridging (IRB) with two Virtual Forwarding Routers (VFRs), BGP must be configured twice. Each VFR will have its own...
How many ports are in each port-group on the S5200 series switches?
How many ports are in each port-group on the S5200 series switches?A . 2B . 6C . 4View AnswerAnswer: C Explanation: Each port-group on the S5200 series switches consists of 4 ports. This grouping allows for efficient management and configuration of the switch ports in sets. References: Dell S5200 Series...
Which three actions can a customer take to change interface Eth1/10 to operate in access mode for VLAN 40?
Refer to the exhibit. Which three actions can a customer take to change interface Eth1/10 to operate in access mode for VLAN 40?A . Configure the access mode for the switch port.B . Delete VLAN 40.C . Shut down the relevant interface.D . Remove the current access VLAN configuration.E ....
What is the cause of the failure?
Refer to the exhibit. Eth 1/1 of SONiC-1 and Eth1/56 of SONiC-2 should be a routed link connecting the two Enterprise SONiC switches. No traffic is passing between them. What is the cause of the failure?A . An incorrect IPv6 address type was used for interface Eth1/56 of SONiC-2.B ....
What type of route is shown?
Refer to the exhibit. What type of route is shown?A . Type 3 host route from external VTEPB . Type 2 host route from another VTEPC . Type 3 host route from another VTEPD . Type 5 host route from another VTEPView AnswerAnswer: B Explanation: The exhibit shows a BGP...
What can be determined from this show command?
Refer to the exhibit. What can be determined from this show command?A . Traffic below 100 KB is marked as congestedB . ECN is enabled for all colorsC . ECN is enabled for all DSCP valuesD . There is a 10% probability that traffic is marked as congestedView AnswerAnswer: B...
What two objectives are they trying to accomplish?
An administrator issues The ztp enable and show ztp status commands. What two objectives are they trying to accomplish?A . Administratively enable the ZTP process.B . Remove the ZTP function from the switch.C . Disable the ZTP process.D . Check on the progress of the ZTP process.View AnswerAnswer: A D...
What interface must be selected when configuring the management port from within the MF-CLI environment?
What interface must be selected when configuring the management port from within the MF-CLI environment?A . mgmt 1/1/1B . ma 0/1C . Management 0D . eth0View AnswerAnswer: D Explanation: Dell SONiC Management Interface Configuration: In Dell SONiC, the management port configuration is a crucial aspect that allows administrators to access...
What router ID is used for Switch 3?
Refer to the exhibit. The router ID has not been manually configured. What router ID is used for Switch 3?A . 192.168.100.2B . 192.168.100.0C . 10.0.2.1D . 10.0.1.1View AnswerAnswer: D Explanation: In the absence of a manually configured router ID, OSPF typically uses the highest IP address on the switch's...
Which network devices route unencapsulated user traffic in a symmetric IRB overlay network?
Which network devices route unencapsulated user traffic in a symmetric IRB overlay network?A . Source VTEP and destination VTEPB . Leaf router and spine routerC . Capability extended next hop router and leaf routerD . Autonomous system boundary router and source VTEPView AnswerAnswer: A Explanation: In a symmetric Integrated Routing...
