What is the most likely cause of the unbalanced power load?
A server room has two power grids, A and B. PSU1 on each server is on grid A, and PSU2 is on grid B. Grid B has significantly lower load compared to grid A. What is the most likely cause of the unbalanced power load? A. PSU1 is a higher...
Which SAS revision sustains a transfer rate of 12 Gb/s for SAS devices?
Which SAS revision sustains a transfer rate of 12 Gb/s for SAS devices?A . SAS 1.0B . SAS 2.0C . SAS 3.0D . SAS 4.0View AnswerAnswer: C
Which type of drive is an array of semiconductor memory organized as a disk drive that uses an integrated circuit?
Which type of drive is an array of semiconductor memory organized as a disk drive that uses an integrated circuit?A . SSDB . SATAC . PATAD . SASView AnswerAnswer: A
What server types offer more disk drives and expansion slots and are the most cost effective within the Dell portfolio?
What server types offer more disk drives and expansion slots and are the most cost effective within the Dell portfolio?A . Tower ServersB . Nano ServersC . Blade ServersD . Rack ServersView AnswerAnswer: A
Which RAID level requires a minimum of four hard drives?
Which RAID level requires a minimum of four hard drives?A . RAID 0B . RAID 1C . RAID 5D . RAID 6View AnswerAnswer: D
Which protocol resolves IP addresses into MAC addresses?
Which protocol resolves IP addresses into MAC addresses?A . ARPB . DHCPC . DNSD . STPView AnswerAnswer: A
Which protocol uses In-Band management for basic communication and messaging?
An administrator sets up an In-Band management method to monitor their Dell EMC PowerEdge servers. Which protocol uses In-Band management for basic communication and messaging?A . SNMPB . HTTPC . SMTPD . FTPView AnswerAnswer: A
What is the expected behavior in this scenario?
A system administrator has Dell EMC PowerEdge server with dual 750W PSUs in a "Not Redundant" configuration with hot spare enabled. One PSU was accidentally removed from the server. What is the expected behavior in this scenario?A . Available power is reduced to a single PSU rated output, and the...
What types of data transfer are used by Dell EMC servers to connect mass storage devices?
What types of data transfer are used by Dell EMC servers to connect mass storage devices?A . USB, Ethernet, SSD, and CSIB . SAS, USB, Ethernet, and SSIDC . SSID, CSI, USB, and SASD . Ethernet, SSID, CSI, and SASView AnswerAnswer: B
What is the correct sequence of steps to set the server into BIOS mode?
A system administrator needs to install an operating system (OS) on a server that is in BIOS mode. What is the correct sequence of steps to set the server into BIOS mode? View AnswerAnswer: