What metrics should be monitored to find the issue?

During a normal workday an administrator notices poor performance (<1MB/s) in combination with poor global compression rate (<1x). What metrics should be monitored to find the issue?A . Cleaning, NVRAM battery level, and link utilizationB . Stream count, CPU utilization, and replicationC . Stream count, disk reconstruction, and replicationD ....

September 4, 2024 No Comments READ MORE +

What is a characteristic of Dell Cloud Tier?

What is a characteristic of Dell Cloud Tier?A . Scales to the maximum capacity of the active tierB . The VTL vault cannot be stored in cloud tier storageC . NFS, HTTPS, and CIFS are supported for data movementD . Managed through a single namespaceView AnswerAnswer: D

September 3, 2024 No Comments READ MORE +

What is the correct practice when creating Fibre Chanel zones between PowerProtect DD and the media server?

What is the correct practice when creating Fibre Chanel zones between PowerProtect DD and the media server?A . dual - initiator dual - target zoningB . single - initiator single - target zoningC . dual - initiator single - target zoningD . single - initiator dual - target zoningView AnswerAnswer:...

September 3, 2024 No Comments READ MORE +

What is a use case of BoostFS

What is a use case of BoostFSA . To protect applications that do not support DD BoostB . To increase DD Boost throughputC . To enable snapshot on DD Boost dataD . To implement DD Boost over Fibre ChannelView AnswerAnswer: A

September 2, 2024 No Comments READ MORE +

What can the administrator disable to address the issue?

An administrator has observed degraded read and write throughput performance with their CIFS share. What can the administrator disable to address the issue?A . Server SigningB . Restrict anonymous connectionC . TCP window sizeD . Log levelView AnswerAnswer: A

September 1, 2024 No Comments READ MORE +

Which compression algorithm will they see enabled by default?

A backup administrator is tasked with verifying the compression savings of a PowerProtect DD9900. Which compression algorithm will they see enabled by default?A . lzwB . gzfastC . lzD . gzView AnswerAnswer: B

September 1, 2024 No Comments READ MORE +

What is the maximum capacity for a DDVE?

What is the maximum capacity for a DDVE?A . 64 TBB . 96 TBC . 128 TBD . 256 TBView AnswerAnswer: B

August 31, 2024 No Comments READ MORE +

When accessing an NFS share from a PowerProtect DD appliance, what is the maximum Mount Limit value for restore instances recommended by IBM Spectrum Protect?

When accessing an NFS share from a PowerProtect DD appliance, what is the maximum Mount Limit value for restore instances recommended by IBM Spectrum Protect?A . 512B . 1024C . 2048D . 4096View AnswerAnswer: D

August 31, 2024 No Comments READ MORE +

What is the minimum tape type to support this requirement?

A Power Protect DD system is configured for VTL. The backup application requires a minimum tape capacity of 800 GB. What is the minimum tape type to support this requirement?A . LTO-5B . LTO-3C . LTO-2D . LTO-4View AnswerAnswer: D

August 31, 2024 No Comments READ MORE +

What is the weekly burn rate (GB) after four daily incremental backups and one weekly backup?

A backup administrator is tasked with monitoring PowerProtect DD capacity metrics. The administrator is backing up 2 TB of data daily with a reduction rate at 5x. After data reduction, subsequent full backups compress down to 100 GB. The initial backup requires 400 GB with a 10 percent increase in...

August 30, 2024 No Comments READ MORE +