D-PDC-DY-23 V1

Refer to the exhibit. Which three commands are used when deploying an automated Leaf and Spine topology using SFS? (Select 3)A . Leaf1(conf)# smartfabric l3fabric enable role LEAF vlti ethernet 1/1/10B . Spine1(conf)# smartfabric l3fabric enable role SPINE preferC . Spine1(conf)# smartfabric l3fabric enable role SPINE downstream ethernet 1/1/1-1/1/2D ....

Multicast flood restrict is a feature enabled by default on OS10 switches to ensure that no traffic drop occurs. What is a recommended configuration step for its implementation?A . Configure the interface between the PIM routers as a dynamic multicast router portB . Enable IGMP snooping on the VLAN interfaces...

How are ACLs processed?A . LIFOB . FIFOC . RandomlyD . SequentiallyView AnswerAnswer: D

What is the default transmission interval of an LLDPDU in SmartFabric OS10?A . 2B . 10C . 20D . 30View AnswerAnswer: D

Refer to the exhibit. Which configuration will allow S1 to ping S2’s Lo0 address?A . S1(config-router)# ip route 144.254.32.1 192.168.32.2/32B . S1(config-router)# ip route 192.168.32.2 144.254.32.1/32C . S1(config)# ip route 144.254.32.1/32 192.168.32.2D . S1(config)# ip route 192.168.32.2 144.254.32.1/32View AnswerAnswer: C

A network administrator has recently configured eBGP to use source addressing from its loopback interfaces. Customers later report that eBGP routes are not being learned. What could be the cause of this issue?A . BGP devices must be configured with the multihop command when using loopback interfacesB . BGPv4 does...

Which OSPF router is responsible for originating Network Link State Advertisements?A . Designated RouterB . Internal RouterC . Area Border RouterD . Backbone RouterView AnswerAnswer: A

When using Policy-Based Routing, what is a valid action?A . Set source IP addressB . Drop packetC . Set destination TCP port numberD . Set 802.1Q VLAN IDView AnswerAnswer: B

What is a benefit of multicast over unicast and broadcast communicationA . Latency is mitigatedB . Bandwidth equally distributed to all devicesC . Minimum network bandwidth useD . Increase of the network loadView AnswerAnswer: C

Interface Ethernet 1/1/3 has been configured with an IP address, and the interface is UP. How does the routing table present the associated network?A . StaticB . Directly connectedC . DynamicD . DefaultView AnswerAnswer: B