- All Exams Instant Download
Which Layer 2 technology is used to segment a switched network?
Which Layer 2 technology is used to segment a switched network?A . TrunkingB . ISLC . LAND . VLANView AnswerAnswer: D
In addition to receiving an IP address, what other information is obtained from a DHCP server?
In addition to receiving an IP address, what other information is obtained from a DHCP server?A . Default gateway address and VLAN IDB . DNS server address and port speedC . Default gateway address and DNS server addressD . DNS server address and VLAN IDView AnswerAnswer: C
Which type of route is often used to direct traffic bound for the Internet?
Which type of route is often used to direct traffic bound for the Internet?A . RedistributedB . Directly connectedC . DynamicD . DefaultView AnswerAnswer: D
Which OS6 command is used to verify the running configuration on port 4?
Which OS6 command is used to verify the running configuration on port 4?A . # show running-config int eth 1/0/4B . # show running-config int gi 1/0/4C . # show running-configuration int gi 1/1/4D . # show running-configuration interface ethernet 1/1/4View AnswerAnswer: B
What is a possible cause of this issue?
A technician configures RIP on a new N-Series switch to connect to an existing switch that runs RIP. The routing table is not populating even after the network statements are added. What is a possible cause of this issue?A . The existing switch has not been configured with the command...
Which command is used to prevent STP learning on a port that is connected to a server?
Which command is used to prevent STP learning on a port that is connected to a server?A . #able spanning-treeB . #spanning-tree securityC . #spanning-tree portfastD . #spanning-tree offView AnswerAnswer: C
Which action occurs when the switch receives a packet on one of its SVIs but the destination IP address of the packet does not match the IP address of that SVI?
A network administrator has a Dell EMC switch that has been configured with several VLANs. Each VLAN switch virtual interface (SVI) has an IP address assigned to it with each of them on different subnets. In addition, routing has been enabled on the switch. Which action occurs when the switch...
What is the default route preference value for a Border Gateway Protocol (BGP) internal route?
What is the default route preference value for a Border Gateway Protocol (BGP) internal route?A . 40B . 110C . 200D . 253View AnswerAnswer: C
Which three switches will auto-negotiate the printers?
A network technician has printers that negotiate at half-duplex. Which three switches will auto-negotiate the printers? (Choose three.)A . X1026B . N2048C . X1008PD . N3024PE . N1548F . N2048PView AnswerAnswer: ACE
What accurately describes the comparison between stacking and VLT?
What accurately describes the comparison between stacking and VLT?A . VLT allows for more physical devices to appear as one virtual device than stacking does.B . Stacked switches share a common control plane while VLT peers maintain their own control planeC . Stacked switches and VLT peers allow “single pane...
