DELL EMC D-PSC-MN-01 Dell PowerScale Maintenance Online Training
DELL EMC D-PSC-MN-01 Online Training
The questions for D-PSC-MN-01 were last updated at Nov 19,2024.
- Exam Code: D-PSC-MN-01
- Exam Name: Dell PowerScale Maintenance
- Certification Provider: DELL EMC
- Latest update: Nov 19,2024
A platform engineer is installing a fully populated Dell PowerScale Gen 6 chassis in a customer rack. However, the equipment lift is broken.
What is the appropriate course of action to take before attempting to lift the chassis?
- A . Remove the power supplies and hard drives, then rack the chassis.
- B . Remove the power supplies and drive sleds while waiting for the lift to be repaired.
- C . Stop work until the lift is repaired and fully functional.
- D . Remove and label the drive sleds and compute modules, then rack the chassis with assistance.
Which tools are used for managing a PowerScale cluster? (Select two)
- A . WebUI
- B . SNMP Manager
- C . CLI
- D . PAPI
What are key considerations when designing the networking architecture for a PowerScale cluster? (Select two)
- A . Network latency
- B . Firewall configurations
- C . Switch capacity
- D . Subnet planning
A platform engineer has added an F200 node to a Dell PowerScale cluster. The cluster now has five F200 nodes.
Before leaving the site, what action must they perform?
- A . Reboot the node and wait for a green status
- B . Ensure the node LNN is set to 1
- C . Test for node connectivity and normal function
- D . SmartFail the node and rejoin to the cluster
When preparing a site for PowerScale installation, which of the following considerations are crucial? (Select two)
- A . Verifying environmental controls are within recommended parameters
- B . Ensuring that the flooring is anti-static
- C . Preparing an emergency evacuation plan specific to the data center
- D . Confirming that data center staff are trained on PowerScale hardware
How can an administrator verify that a node is successfully shut down?
- A . Verify the LEDs on the front panel are not lit.
- B . Execute the isi status -q command and see that the node is in a D— status.
- C . Execute the isi status -q command and see that the node is in an A– status.
- D . Try to access a share on the node and verify the share is inaccessible.
What is a precaution when working with Dell PowerScale equipment?
- A . Nodes can operate below 5 degrees C, but only for limited periods of time
- B . The total rack load should not exceed 70% of the branch circuit rating
- C . Use side stabilizers if the rack is not bolted to the floor
- D . Connections to the branch circuit need not be properly grounded
Which statement is accurate regarding Dell PowerScale firmware updates?
- A . Drive firmware updates require a reboot.
- B . Update can only be applied to a node in maintenance mode.
- C . Firmware updates require a serial connection to the node.
- D . Node firmware updates require a reboot.
Which Dell PowerScale interface is the simplest to use for customers?
- A . OneFS command line
- B . Platform application interface
- C . Serial console
- D . Web administration interface
What protocols are essential for secure remote PowerScale cluster management? (Select two)
- A . SNMPv3
- B . SSH
- C . HTTP
- D . RDP