DELL EMC D-PE-OE-23 Dell Technologies PowerEdge Operate 2023 Online Training
DELL EMC D-PE-OE-23 Online Training
The questions for D-PE-OE-23 were last updated at Nov 23,2024.
- Exam Code: D-PE-OE-23
- Exam Name: Dell Technologies PowerEdge Operate 2023
- Certification Provider: DELL EMC
- Latest update: Nov 23,2024
Which characteristic of system management enables a company to reduce costs?
- A . Integration with third-party tools
- B . Multi-tenancy support
- C . Rich management interface
- D . Automation of routine tasks
On a PowerEdge R640 server, the System Lockdown mode has been enabled. Certain features are no longer available in the System BIOS utility or IDRAC GUI.
Which other feature is no longer available?
- A . OMSA
- B . Lifecycle Controller
- C . iSM
- D . Booting to a 32-bit OS
A system administrator is trying to connect with a mobile device to a Dell PowerEdge 16G server using Quick Sync 2. They failed to make a connection.
What is the reason for the failure?
- A . Bluetooth is disabled on the mobile device.
- B . NFC is disabled on the mobile device.
- C . There is no iDRAC IP address configured.
- D . The mobile device is using iOS.
An engineer needs to install an additional PSU on an existing, single PSU Dell EMC PowerEdge R740. They complete the initial installation and cabling procedures. They connect an AC cable and the power distribution unit produces normal AC output. The engineer checks power management and sees that the new PSU is in the Failed state.
What task should be completed to troubleshoot this issue?
- A . Confirm the System Input Power CAP is not set to Low
- B . Set the PSU AC redundancy to 1+1
- C . Set the PSU AC redundancy to 1+0
- D . Verify the new PSU is the same type and wattage rating
A new server with default iDRAC network configurations is plugged into a segregated management network configured for 10.0.0.x/24. The technician cannot connect to the iDRAC.
How can the on-site technician configure the iDRAC for network access?
- A . Change iDRAC network settings from a workstation on the management network
- B . Perform an AC power cycle to reset the iDRAC
- C . Modify the iDRAC settings using the iDRAC Direct feature
- D . Configure a DHCP reservation for the iDRAC MAC address
A technician is deploying a server.
What should they do once the server is fully configured and deployed?
- A . Switch on write-protect for the vFlash SD card
- B . Back up the server profile and reset the iDRAC to Default Settings
- C . Back up the server profile and configure the Parts Replacement feature
- D . Change the iDRAC secure password based on the users’ company policies
Latest D-PE-OE-23 Dumps Valid Version with 270 Q&As
Latest And Valid Q&A | Instant Download | Once Fail, Full Refund
