DELL EMC D-NWG-FN-23 Dell Networking Foundations 2023 Online Training
DELL EMC D-NWG-FN-23 Online Training
The questions for D-NWG-FN-23 were last updated at Feb 20,2025.
- Exam Code: D-NWG-FN-23
- Exam Name: Dell Networking Foundations 2023
- Certification Provider: DELL EMC
- Latest update: Feb 20,2025
Which IP address belongs to the same subnet as 192.168.8.10/22?
- A . 192.168.1.192
- B . 192.168.5.16
- C . 192.168.10.1
- D . 192.168.0.3
If a packet is sent to an IPv6 address and many devices receive the packet, what is this type of traffic?
- A . Multicast
- B . Broadcast
- C . Anycast
- D . Unicast
Which field of the 802.3 frame is used by network interface cards to synchronize their receivers?
- A . Start frame delimiter
- B . Preamble
- C . Cyclic redundancy check
- D . Frame check sequence
Which Layer 2 technology is used to segment a switched network?
- A . Trunking
- B . ISL
- C . LAN
- D . VLAN
How many total addresses for network, broadcast, and host are provided with the subnet mask 255.255.255.240?
- A . 8
- B . 16
- C . 24
- D . 48
A technician implements a new copper connection to Gi2/0/20.
Which command should be used to check the cable length?
- A . test tdr copper-length gigabitethernet 2/0/20
- B . test copper-length tdr gigabitethernet 2/0/20
- C . test tdr copper-port gigabitethernet 2/0/20
- D . test copper-port tdr gigabitethernet 2/0/20
Which Layer 1 device can be used to enlarge the area covered by a single LAN segment?
- A . Router
- B . Repeater
- C . Switch
- D . NIC
A technician has one stack of three N3024. The technician removes the master unit without powering off the stack. This unit is reconfigured with new IP address in the same Layer 2 network.
Which management issue is the result?
- A . A duplicate MAC address
- B . A duplicate IP address
- C . Lost switch configuration
- D . A switch that flashes red LED
Refer to the output:
How has OSPF been configured?
- A . For network type broadcast
- B . With a dead-timer mismatch
- C . For network type point-to-point
- D . With a Peer-to-Peer LSA learning of type 7 LSAs
A technician wants to allow SSH connections to authenticate using an external server. If the external server becomes unreachable, the users created on the switch should be allowed.
What command will accomplish this goal?
- A . AAA authentication login default radius local
- B . AAA authentication ssh default radius enable
- C . AAA authentication login default local radius
- D . AAA authentication ssh default radius none
Latest D-NWG-FN-23 Dumps Valid Version with 221 Q&As
Latest And Valid Q&A | Instant Download | Once Fail, Full Refund
