CompTIA N10-008 CompTIA Network+Exam Online Training
CompTIA N10-008 Online Training
The questions for N10-008 were last updated at Jan 28,2025.
- Exam Code: N10-008
- Exam Name: CompTIA Network+Exam
- Certification Provider: CompTIA
- Latest update: Jan 28,2025
An engineer notices some late collisions on a half-duplex link. The engineer verifies that the devices on both ends of the connection are configured for half duplex.
Which of the following is the MOST likely cause of this issue?
- A . The link is improperly terminated
- B . One of the devices is misconfigured
- C . The cable length is excessive
- D . One of the devices has a hardware issue
A network administrator is configuring a load balancer for two systems.
Which of the following must the administrator configure to ensure connectivity during a failover?
- A . VIP
- B . NAT
- C . APIPA
- D . IPv6 tunneling
- E . Broadcast IP
A technician is troubleshooting a wireless connectivity issue in a small office located in a high-rise building. Several APs are mounted in this office. The users report that the network connections frequently disconnect and reconnect throughout the day.
Which of the following is the MOST likely cause of this issue?
- A . The AP association time is set too low
- B . EIRP needs to be boosted
- C . Channel overlap is occurring
- D . The RSSI is misreported
A network engineer configured new firewalls with the correct configuration to be deployed to each remote branch. Unneeded services were disabled, and all firewall rules were applied successfully.
Which of the following should the network engineer perform NEXT to ensure all the firewalls are hardened successfully?
- A . Ensure an implicit permit rule is enabled
- B . Configure the log settings on the firewalls to the central syslog server
- C . Update the firewalls with current firmware and software
- D . Use the same complex passwords on all firewalls
At which of the following OSI model layers would a technician find an IP header?
- A . Layer 1
- B . Layer 2
- C . Layer 3
- D . Layer 4
An engineer is configuring redundant network links between switches.
Which of the following should the engineer enable to prevent network stability issues?
- A . 802.1Q
- B . STP
- C . Flow control
- D . CSMA/CD
Several WIFI users are reporting the inability to connect to the network. WLAN users on the guest network are able to access all network resources without any performance issues.
The following table summarizes the findings after a site survey of the area in question:
Which of the following should a wireless technician do NEXT to troubleshoot this issue?
- A . Reconfigure the channels to reduce overlap
- B . Replace the omni antennas with directional antennas
- C . Update the SSIDs on all the APs
- D . Decrease power in AP 3 and AP 4
Which of the following routing protocols is used to exchange route information between public autonomous systems?
- A . OSPF
- B . BGP
- C . EGRIP
- D . RIP
A fiber link connecting two campus networks is broken.
Which of the following tools should an engineer use to detect the exact break point of the fiber link?
- A . OTDR
- B . Tone generator
- C . Fusion splicer
- D . Cable tester
- E . PoE injector
Which of the following can be used to centrally manage credentials for various types of administrative privileges on configured network devices?
- A . SSO
- B . TACACS+
- C . Zero Trust
- D . Separation of duties
- E . Multifactor authentication
Latest N10-008 Dumps Valid Version with 132 Q&As
Latest And Valid Q&A | Instant Download | Once Fail, Full Refund
