Check Point 156-836 Check Point Certified Maestro Expert – R81 (CCME) Online Training
Check Point 156-836 Online Training
The questions for 156-836 were last updated at Nov 22,2024.
- Exam Code: 156-836
- Exam Name: Check Point Certified Maestro Expert - R81 (CCME)
- Certification Provider: Check Point
- Latest update: Nov 22,2024
At a minimum, how many management and Uplink ports does a SG require?
- A . Only one of the two interfaces is needed for the Security Group.
- B . Neither are required.
- C . Two of each.
- D . One each.
What is the maximum number of Appliances within the same Security Group?
- A . 31
- B . 8
- C . 52
- D . 16
For the MHO-175, which ports are Management ports?
- A . Ports 49 – 55 are Management ports.
- B . Ports 1 – 4 are Management ports.
- C . Ports 27 – 47 are Management ports.
- D . Ports 5 – 26 are Management ports.
What kinds of transceivers are supported on Orchestrator MHO-140?
- A . SFP, QSFP, QSFP28
- B . SFP+, SFP28, QSFP
- C . SFP, SFP+, SFP28
- D . SFP, SFP+, QSFP, QSFP28
What happens if the SMO Master fails?
- A . The next SGM with the current lowest SGM ID assumes the role of the SMO Master.
- B . The Backup SMO Master will take over in the event of a failure with the SMO Master.
- C . A failover will occur on the MHO and traffic will continue to pass.
- D . The Security Group will no longer pass traffic and the issue must be resolved with the SMO Master.
What does the lldpctl command do?
- A . Show all devices discovered by LLDP protocol on downlink ports
- B . Show all devices discovered by LLDP protocol on all ports
- C . Discover orchestrators
- D . Show all devices discovered by LLDP protocol on uplink ports
What type of cluster can a Security Group can be compared to?
- A . Load Sharing Active / Active
- B . VSLS
- C . Active / Backup
- D . Active / Standby
What kinds of transceivers are supported on Orchestrator MHO-170?
- A . SFP, QSFP, QSFP28
- B . SFP+, SFP28, QSFP
- C . SFP, SFP+, SFP28
- D . QSFP, QSFP28
There are two 10Gbps dual-port NICs and one 40Gbps NIC installed on a 23800 Appliance in slots 1, 2 and 3 accordingly.
Which interfaces should be connected to Orchestrator 1 for downlinks’ intra-orchestrator redundancy when using two Orchestrators?
- A . Port 1 in Slot 2 and Port 2 in Slot 1
- B . This configuration is not supported
- C . Any pair of available ports
- D . Port 1 in Slot 1 and Port 2 in Slot 1
Which licenses should be issued for the Orchestrator?
- A . No licenses are required for Orchestrator
- B . Depends on Software Blades enabled on connected appliances
- C . The Orchestrator is considered a Management server, hence it’s licensed the same way
- D . The Orchestrator requires NGTX license
Latest 156-836 Dumps Valid Version with 64 Q&As
Latest And Valid Q&A | Instant Download | Once Fail, Full Refund
