Based on the screenshots above, and with no configuration inside the Template Stack itself, what access will the device permit on its Management port?

Based on the screenshots above, and with no configuration inside the Template Stack itself, what access will the device permit on its Management port?

A . The firewall will allow HTTP Telnet, HTTPS, SSH, and Ping from IP addresses defined as $permitted-subnet-1.
B . The firewall will allow HTTP Telnet, HTTPS, SSH, and Ping from IP addresses defined as $permitted-subnet-2.
C . The firewall will allow HTTP, Telnet, SNMP, HTTPS, SSH and Ping from IP addresses defined as $permitted-subnet-1 and $permitted-subnet-2.
D . The firewall will allow HTTP, Telnet, HTTPS, SSH, and Ping from IP addresses defined as $permitted-subnet-1 and $permitted-subnet-2.

View Answer

Answer: A

Explanation:

https://live.paloaltonetworks.com/t5/panorama-discussions/panorama-force-template-value-option/td-p/496620 "- Force Template Value will as the name suggest remove any local configuratio and apply the value define the panorama template. But this is valid only for overlapping configuration" "You need to be careful, what is actually defined in the template. For example – if you decide to enable HA in the template, but after that you decide to not push it with template and just disable it again (remove the check from the "Enable HA" checkbox). This still will be part of the template, because now your template is explicitely defining HA disabled. If you made a change in the template, and later decide that you don’t want to control this setting with template, you need to revert the config by clicking the green bar next to the changed value"