An empty configuration MSR router RTA is connected to two routers RTB and RTC running in OSPF Area 0 through GE0 / 0 and GE1 / 0 respectively . RTA interface GE0 / 0 and GE1 / 0 of the IP addresses are 192.168.3.2/24 and 192.168.4.2/24 . Add the following configuration on RTA :

 An empty configuration MSR router RTA is connected to two routers RTB and RTC running in OSPF Area 0 through GE0 / 0 and GE1 / 0 respectively . RTA interface GE0 / 0 and GE1 / 0 of the IP addresses are 192.168.3.2/24 and 192.168.4.2/24 . Add the following configuration on RTA :

[MSR-ospf-1] area 0.0.0.0

[MSR-ospf-1-area-0.0.0.0]network 192.168.0 0.0.3.255

[MSR-GigabitEthernet0/0]ospf cost 2

[MSR-GigabitEthernet1/0]ospf dr-priority 0

Then the correct description about the above configuration is _____ . (Multiple choices)
A .  This configuration MSR router the GE0 / 0 , GE1 / 0 on both started OSPF
B .  This configuration only MSR router GE0 / 0 interface launched OSPF
C . RTA may become the DR of the network segment where the two GE interfaces are located
D . RTA can only become the DR of the network segment where one of the GE interfaces is located
E .  modify the interface GE0 / 0 of Cost does not affect the OSPF adjacency establishment of

View Answer

Answer: BDE

Explanation:

[MSR-ospf-1-area -0.0.0.0] network 192.168.0 0.0.3.255 mask 22 , as described in the interface segment 0.0 , 1.0 , 2.0 , 3.0 Startup ospf G1 / 0 interface priority to 0 , The interface with priority 0 does not participate in DR , BDR election