What is the reason the trunk does not form, even thought the proper cabling has been attached?

Refer to the exhibit.

Switch port FastEthernet 0/24 on AlSwitch1 will be used to create an IEEE 802.1Q­complaint trunk to another switch. Based on the output shown.

What is the reason the trunk does not form, even thought the proper cabling has been attached?
A . VLANs have not been created yet.
B . An IP address must be configured for the port.
C . The port is currently configured for access mode.
D . The correct encapsulation type has not been configured.
E . The no shutdown command has not been entered for the port.

View Answer

Answer: C