If you continued configuring the controller, what are the reasons why the deployment will fair?

After setting up an SC4020 and turning on the system, both controllers initialize to Safe Mode and are ready for configuration You plug the serial cable into the first controller and type the platform prejoin show command You then receive the command output shown in the exhibit

If you continued configuring the controller, what are the reasons why the deployment will fair?
A . Serial cable needs to be plugged into the top controller Controller chassis is installed upside down in the rack
B . Serial cable needs to be plugged into the top controller eth1 IPv4 IP address used at the factory to load the firmware was not cleared before shipping
C . Serial cable needs to be plugged into the bottom controller eth1 IPv4 IP address used at the factory to load the firmware was not cleared before shipping
D . Serial cable needs to be plugged into the bottom controller Controller chassis is installed upside down in the rack

View Answer

Answer: D