DELL EMC D-SNC-DY-00 Dell SONiC Deploy Exam Online Training
DELL EMC D-SNC-DY-00 Online Training
The questions for D-SNC-DY-00 were last updated at Feb 20,2025.
- Exam Code: D-SNC-DY-00
- Exam Name: Dell SONiC Deploy Exam
- Certification Provider: DELL EMC
- Latest update: Feb 20,2025
Refer to the exhibit.
What is the purpose of the static route?
- A . Provide a route to the 12.0.0.0 network.
- B . Provide a route to the 192.168.45.0 network.
- C . Verify that the 12.0.0.0 network is active and reachable.
- D . Verify that devices in VLAN 45 are reachable.
What is ECMP?
- A . A Layer 3 routing feature to forward traffic using multiple available paths
- B . A routing protocol database filter supporting a maximum of four paths
- C . A round-robin path distribution mechanism
- D . A routing protocol with multipath support
Refer to the exhibit.
Eth 1/1 of SONiC-1 and Eth1/56 of SONiC-2 should be a routed link connecting the two Enterprise SONiC switches. No traffic is passing between them.
What is the cause of the failure?
- A . An incorrect IPv6 address type was used for interface Eth1/56 of SONiC-2.
- B . A spanning-tree is blocking the routed link.
- C . IPv6 is not enabled on interface Eth 1/1 of SONiC-1.
- D . There is a cable that is unplugged between SONiC-1 and SONiC-2.
Refer to the exhibit.
What type of route is shown?
- A . Type 3 host route from external VTEP
- B . Type 2 host route from another VTEP
- C . Type 3 host route from another VTEP
- D . Type 5 host route from another VTEP
How many times must BGP be configured when running symmetric IRB with two VFRs?
- A . 3
- B . 5
- C . 2
- D . 4
What is the purpose of the write erase boot command option?
- A . Delete the startup and enable zero touch provisioning.
- B . Remove user-installed packages and tile changes.
- C . Delete the startup configuration and the management interface configuration.
- D . Delete the running configuration and all user accounts.
Refer to the exhibit.
Which three actions can a customer take to change interface Eth1/10 to operate in access mode for VLAN 40?
- A . Configure the access mode for the switch port.
- B . Delete VLAN 40.
- C . Shut down the relevant interface.
- D . Remove the current access VLAN configuration.
- E . Enter it into the relevant interface.
How many ports are in each port-group on the S5200 series switches?
- A . 2
- B . 6
- C . 4
Which network devices route unencapsulated user traffic in a symmetric IRB overlay network?
- A . Source VTEP and destination VTEP
- B . Leaf router and spine router
- C . Capability extended next hop router and leaf router
- D . Autonomous system boundary router and source VTEP
Refer to the exhibit.
The router ID has not been manually configured.
What router ID is used for Switch 3?
- A . 192.168.100.2
- B . 192.168.100.0
- C . 10.0.2.1
- D . 10.0.1.1
Latest D-SNC-DY-00 Dumps Valid Version with 45 Q&As
Latest And Valid Q&A | Instant Download | Once Fail, Full Refund
