What should you do?

Your network contains a server named Server1 that has the Network Policy and Access Services server role installed. All of the network access servers forward connection requests to Server1. You create a new network policy on Server1. You need to ensure that the new policy applies only to connection requests from the 192.168.0.0/24 subnet.

What should you do?
A . Set the Client IP4 Address condition to 192.168.0.0/24.
B . Set the Client IP4 Address condition to 192.168.0.
C . Set the Called Station ID constraint to 192.168.0.0/24.
D . Set the Called Station ID constraint to 192.168.0.

View Answer

Answer: B

Explanation:

RADIUS client properties

Following are the RADIUS client conditions that you can configure in network policy.

• Calling Station ID: Specifies the network access server telephone number that was dialed by the dial-up access client.

• Client Friendly Name: Specifies the name of the RADIUS client that forwarded the connection request to the NPS server.

• Client IPv4 Address: Specifies the Internet Protocol (IP) version 4 address of the RADIUS client that forwarded the connection request to the NPS server.

• Client IPv6 Address: Specifies the Internet Protocol (IP) version 6 address of the RADIUS client that forwarded the connection request to the NPS server.

• Client Vendor: Specifies the name of the vendor or manufacturer of the RADIUS client that sends connection requests to the NPS server.

• MS RAS Vendor: Specifies the vendor identification number of the network access server that is requesting authentication.